Hey there folks,

I’m trying to figure out how to configure my UFW, and I’m just not sure where to start. What can I do to see the intetnet traffic from individual apps so I can know what I might want to block? This is just my personal computer and I’m a total newbie to configuring firewalls so I’m just not sure how to go about it. Most online guides seem to assume one already knows what they want to block but I don’t even know how/where to monitor local traffic to figure out what I can/should consider blocking.

    • ReversalHatchery@beehaw.orgEnglish
      2·
      2 months ago

      run sudo ss -tulpn, and have a look at the processes and their privileges listening for incoming connections. If one of them has a vulnerability, through which a third party can make that software do things it was not intended for… that’s pretty bad.
      This can most easily happen with software whose developers are underresouced/careless/stubborn.

      A recent case of that happening: https://www.evilsocket.net/2024/09/26/Attacking-UNIX-systems-via-CUPS-Part-I/
      Tl;Dr, remote code execution vulnerability in software that most often runs as root, automatically.

      • Possibly linux@lemmy.zipEnglish
        1·
        2 months ago

        You don’t understand local host. Services listen on 127.0.0.1 which is a local only address. You can only connect to it locally

      • drkt@lemmy.dbzer0.com
        1·
        2 months ago

        I understand your point but I reiterate that I don’t connect to unsafe networks. If someone has remote code execution on a device on my side of the network then they are also inside my apartment and I’d be more worried about that.