I voted.

These next four years are for you.

Yes. The Robert’s decision blatantly violated the Constitution.

Way too many variables. Are you shooting 9mm, 45, .338 Lapua, .22lr? Are you shooting from a 9 in barrel, a 16 in, a three inch? Are you using a muffler? What brand and type? What is your range to the gun shot? Is the bullet supersonic or subsonic? Does the roofers hammer make a sound that falls inside the wide range of noises? There is no way to make an accurate profile for gun shot noise.

I think there must be a large number of men who can’t admit that they are bisexual or on the sexual spectrum. I see lots of commitment like this. “I am a heterosexual but i like dick” “I am Straight but…” If you like it enough for it to keep you hard, you are not completely straight. Of course that is fine, it is okay to say that gay4pay is gay or bi.

This has to be one of the craziest weapons ever made. An unguided, nuclear, air-to-air rocket.

Go for an iron with temperature control and a fine, chisel tip. There are many good brands, Weller is market leader, but cheaper irons can work well too. The chisel tip adds more surface area for more heat conduction.

Flux is very important. No good soldering happens without Flux. Also important to keep a clean tip. I recommend tinning the wire or the contact pad and tinning the iron tip. This should give you enough solder to make the joint without having to hold a piece of solder.

I love Cardas Audio Quad-Enteric solder https://www.cardas.com/supplies Super low melting point makes it great for electronics parts that might be damaged by too much heat.

Speak for yourself.