Are you unpacking them directly on your NAS?

Because chances are, that if you use a Synology and map the drive or use the GUI, that the data keeps getting transferred between your PC and the NAS. This is a very slow process, especially if you connect by WiFi.

That is correct, this is the standard procedure to dry PCBAs.

You lost your pad. This usually happens if you have old PCBs which were exposed to some air humidity over time. The pad heats up and the moisture evaporates between the layers, separating the pad and the PCB base material. More heat increases the likelihood of that happening.

That part is unsolderable now. You need to connect at a different place and reconnect any interrupted traces or glue the pad back to the board, if you can.

Game controllers in general are very hard to repair since they contain large copper layers to withstand forces from the controls. It’s very common to loose pads or lift THT holes.

That said, most often nothing is ever beyond repair. It’s usually just a matter of skills and tools which are available.

You have nothing to hide, right?

Around 2005 Europeans used SMS quite often while the US didn’t seem to use it at all. Then a few years later it was all done by WhatsApp since it was more or less for free. And now we’re having blue/green bubble discussions.

Have we gone full circle and are using actual SMS again?